Legacy Products
The resources associated with these products have ceased their development and are no longer supported.
D-Link Systems, Inc. recommends retiring these products and replacing them with products that receive firmware updates.
What is the proper procedure to reset the DI-704, DI-704P, DI-713P, DI-804HV, and DI-808HV to factory settings?

This reset procedure applies to the following devices:

  • DI-704
  • DI-704P
  • DI-713
  • DI-713P
  • DI-714P+
  • DI-804HV
  • DI-808HV

    Step 1 Power the unit off by unplugging its power adapter.

    Step 2 Insert a paper clip in to the reset pinhole. Press and hold the reset button with light pressure.

    Step 3 Power the device back on by plugging it in. Continue to hold the reset button.

    Step 4 Watch the lights on the front of the router. The M1 & M2 should come on solid. When the M1 & M2 begin to blink slowly, release the reset button.

    The unit will reboot itself and should be at factory defaults. If the M1 light is not blinking about once per second, unplug the power on the router and plug it back in.

    If the M1 & M2 continue to blink rapidly, you held the reset button for too long. Power the device off and repeat the reset procedure.

    The default IP address is The default username for our routers is admin. The password is blank. If your router asks only for a password, use admin (lower-case).