Legacy Products
The resources associated with these products have ceased their development and are no longer supported.
D-Link Systems, Inc. recommends retiring these products and replacing them with products that receive firmware updates.
How can I access the configuration page of my DPR-1260?

After firmware version 1.12, the DPR-1260 is defaulted to DHCP unless the unit was previously configured for a Static IP Address.

NOTE:You MUST have the DPR-1260 connected to a router/DHCP Server for Inital Configuration.

DHCP means the router is dynamicly assigning an IP Address to the DPR-1260. There are a few ways to access the device in this configuration.

  • Option 1:
    You can invoke the unit with its UPnP icon in My Network Places. If you do not see a UPnP icon for the DPR-1260 in your Network Places, you may need to click the Show UPnP Icons In Networked Devices under the Network Tasks window in the upper left of the My Network Places window.



     
  • Option 2:
    If your router provides a DHCP client list, you could confirm it-¦s IP Address by referencing it's MAC Address and locating the IP Address that the router is assigning to the unit.
    Note: Not all routers support this option.


    Note: DIR-655 DHCP table used in this image.

     
  • Option 3:
    The DPR-1260 also has a "Friendly" name. This can be used to gain access to the DPR-1260 when it's IP Address is not known.

    Note: the "Friendly" name the DPR-1260 uses depends on the version of the firmware it has loaded.



     
  • Note: Firmware 1.21 "friendly" name used in this image.